Skip to content

Configuring comparisons

To exclude certain lines from the comparison, you can configure the comparator for Bosch Tightening system components.

The editor from Haller and Erne adds a timestamp to each backup of the files. This would basically detect differences every time a backup is compared with a previous backup or version. To avoid this at, the following strings must be excluded:

  • in CRC files "LAST_CHANGE"

Figure: Configure Comparison dialog, CRC files

  • in TXT files "firmware"

Figure: Configure Comparison dialog, TXT files

Info

The comparison can only be configured if project data has been versioned in the component.

You can customize the comparison on a component-specific basis or in the Job configuration section for each job. To customize the comparison for the component, proceed as follows:

  1. Start the UserClient.
  2. Select your component.
  3. Right-click on the component and select the Edit component configuration menu item.
  4. The Component configuration dialog opens.
  5. Click on the Configure comparator button.
  6. The Comparison configuration dialog opens.