Skip to content

Creating jobs

Jobs for the backup of Schneider EcoStruxure Machine Expert projects are created with the upload type CODESYS using CODESYS V3.

  1. Start the AdminClient and open the Jobs module.
  2. Select your Schneider Schneider EcoStruxure Machine Expert component in the Project tree.
  3. Click on the Create button in the ribbon or drag and drop the component into the Jobs section.
  4. Check whether the CODESYS upload type is displayed in the Job configuration section.
  5. Configure the general sections General, Notification, Upload and compare and Create a version automatically after job run. The sections Notification and Create a version automatically after job run are only displayed if the settings required for this have been made.

  6. Make the following settings in the CODESYS settings section:

    Figure: Job configuration, CODESYS settings section

    1. In the Project dropdown menu, select the project for which the upload is to take place. Only projects are displayed here that are contained in the selected component and are checked in on the server.
    2. In the Interface Type dropdown menu, select one of the Gateway V3 or ARTI V3 entries. Alternatively, you can also enter the entry "interfacetype=..." in the Access parameters input field.
    3. Enter the connection data of the Gateway in the Gateway IP, Gateway port and Gateway password fields. If no port is specified here and in the Access parameters field, the default port 1217 is used.
    4. In the Device, PLC IP and PLC port fields, enter the connection data of the device. If no port is specified here or in the Access parameters field, the default port 11740 is used.
    5. Enter your access data for the device in the User account and User password fields.

    6. The access data that you can enter in the fields above can also be listed in the Access parameters field.

      Info

      If data is entered both in the individual fields above and in the Access Access parameters field below and these differ, the entries in the Access parameters field are preferred for reasons of backward compatibility.

      The following parameters must be given special importance in any case:

      • value0={IP address of the PLC}
      • value1={Port Nr.}

  7. Save the job and test it with Execute selected jobs once.

Info

You can implement further settings for jobs of this upload type in the AdminClient in the Global settings dialog.