Skip to content

Creating jobs

  1. Start the AdminClient and open the Jobs module.
  2. Select your Modsoft component in the Project tree.
  3. Click on the Create button in the ribbon or drag and drop the component into the Jobs section.
  4. Go to the Job configuration column in the right-hand area of the interface. Check the upload type there and configure the General and Upload and compare fields.
  5. Configure the Schneider Modsoft settings.
    1. Select the Schneider Modsoft project from the Project dropdown menu. This option is only relevant if there is more than one project in the component.
    2. Use the Access path dropdown menu to select the path for communication with the device. The paths PC->[TCP/IP]->PLC and PC->[TCP/IP]->Gateway->[MODBUS+]->PLC are available for selection. The option BridgedModbusPlus is only available if you have selected the access path PC->[TCP/IP]->Gateway->[MODBUS+]->PLC.
    3. Enter the IP address or the name of the Device.
    4. Under Advanced, you can set a delay of 0 ms to 5000 ms with the option Sleep between two subsequent frames (in ms). The default value is 0ms. Higher values are recommended if there is interference or transmission errors.