Skip to content

Siemens SINUMERIK Operate

octoplant supports the automatic creation of backups and the cyclic monitoring of SINUMERIK Operate devices.

Device support level

Figure: Device Support Level Siemens SINUMERIK Operate

Key features

Figure: Siemens SINUMERIK Operate Key features

Workflow

Figure: Workflow Siemens SINUMERIK Operate

System requirements

SINUMERIK 840D Operate 2.7 4.5 4.7 4.8 4.9
octoplant 101
octoplant 101.1.0

Other requirements

  • The SINUMERIK Operate plugin must be installed on the HMI (NCU or PCU).
  • To perform an S7 comparison with the backup, the corresponding S7 project has to be included into the same SINUMERIK 840D component.

To get the basic workflow for intergrating the device, open General workflow.

Device-specific settings for this device, such as job configuration, can be found on the following pages: