Skip to content

RSLogix 500

octoplant supports programmable logic controllers that work with the RSLogix 500 software (the SLC™ 500 and MicroLogix™ product families) and enables the cyclical monitoring of devices configured with this development environment.

Device support level

Figure: Device Support Level RSLogix 500

Key features

Figure: RSLogix500 Key features

Other features

  • Asset inventory support

Workflow

Figure: Workflow RSLogix 500

Supported versions

RSLogix 500 V 9.x V 10.x V 11 V 12
octoplant 101 ✓ ✓ ✓ ✓

Requirements

  • To perform uploads, ensure the following software versions are installed on the same machine where the octoplant server or agent is running:

    • RSLogix 500 (Standard and Professional Edition)
    • RSLinx Classic (version 3.51 or later) or FactoryTalk Linx (formerly RSLinx Enterprise Edition, version 5.51 or later)

  • If you are upgrading to FactoryTalk Linx:

    • Uninstall RSLinx Classic before proceeding with the upgrade.
    • Manually reconfigure the communication path in the Job configuration section.
    • If you are using agents, make sure they are running with administrative privileges.

  • You can find the system requirements for RSLogix 500 on the Rockwell Automation website.

  • To support uploads, the VDog MasterService, VDog UploadAgent, and VDog CompareAgent services must not run under the LocalSystem account. Instead, use an administrator account or one with administrative rights.

  • To ensure reliable communication, it is recommended to launch either the agent or the VDog MasterService (whichever is in use for this device) as an application, under the following conditions:

    • If the RSLogix software is installed on a different machine, agents are required on that machine.
    • Agents must be capable of launching and interacting directly with the RSLogix software.
    • The setup requires both administrative rights and access to the user interface.

    For detailed instructions, see Starting agents and VDog MasterService as applications.

Configuration

To get the basic workflow for intergrating the device, open General workflow.

Device-specific settings for this device, such as job configuration, can be found on the following pages: