Siemens SINUMERIK Operate
versiondog supports the automatic creation of backups and the cyclic monitoring of SINUMERIK Operate devices.
Device support level
Key features
- The functions shown in gray are currently not supported.
System requirements
| SINUMERIK 840D Operate | 2.7 | 4.5 | 4.7 | 4.8 | 4.9 |
|---|---|---|---|---|---|
| versiondog 5.5 | ✓ | ✓ | ✓ | ||
| versiondog 7.0 | ✓ | ✓ | ✓ | ✓ | |
| versiondog 9.7 | ✓ | ✓ | ✓ | ✓ | ✓ |
Other requirements
- The SINUMERIK Operate plugin must be installed on the HMI (NCU or PCU).
- To perform an S7 comparison with the backup, the corresponding S7 project has to be included into the same SINUMERIK 840D component.
Related topics
To get the basic workflow for intergrating the device, open General workflow.
Device-specific settings for this device, such as job configuration, can be found on the following pages: